OPTEX FA Fastus UR-MS16DT User Manual page 5

WARNING
If the CC-Link IE Field/TSN communication stops, the process output data is held or cleared ac-
cording to the "IO-Link and network error handling" of the Master parameters in this product. It
At this time, take safety measures outside this product so that the system works on the safe side.
If the IO-Link communication fails, the process input data is held or cleared according to the "IO-
Link and network error handling" of the Master parameters in this product.
At this time, take safety measures outside this product so that the system works on the safe side.
What to do in the event of a malfunction such as smoke being emitted from the product
If you detect any malfunction including emission of smoke, abnormal smells or sounds, or the
Repairing the product is dangerous and should in no way be performed by the customer. Contact
an OPTEX FA sales representative for repairs.
What to do if water enters the product
If water or any other liquid enters the product or the cable, immediately stop operating the prod-
CAUTION
Do not touch this product or the cable with wet hands. Doing so may damage the product.
-
uals.
Incorrect wiring can cause product failure or malfunction.
Keep wiring separate from high voltage and motor circuits.
Using the same wiring can cause malfunction or failure.
If this is unavoidable, shield with a conductor such as an earthed conduit.
Install this product as far away as possible from high-voltage equipment, equipment that gener-
ates large switching surges and equipment that generates noise, such as welding machines or
inverter motors.
Use this product with the included end plate mounted to the DIN rail.
Make sure locking mechanisms are locked before use.
Tighten the mounting screws that attach the power terminal block to the main unit with a torque
value of 0.25 N•m or less.
Do not apply torsional stress to cables. Doing so can cause cables and connectors to malfunc-
tion.
Secure the communications cable drawn out of this product within lengths of 30 cm to ensure no
load is applied to the product.
Safety Precautions
iii
Ramco Innovations www.optex-ramco.com (800) 280-6933