OPTEX FA Fastus UR-MS16DT User Manual page 152

Phenomenon LEDs on the front Cyclic
of this product
Data sent ALARM
to/received LED ON
from an IO-
Link device red
via IO-Link
communication
cannot be
read/written
properly by
CC-Link IE
Field/TSN
Storage data ALARM
cannot be restored LED ON
to the IO-Link
device using the red
manual backup/
restore of settings
or automatic
device parameter
backup functions.
Unable to ALARM -
LED OFF
perform the
following using
• Parameter
reading
• Parameter
writing
• CC-Link IE
Field network
diagnosis
The unique
setting values
of an IO-Link
device cannot
be displayed/
written using the
IO-Link device
unique setting
values window
on the front of
this product.
Troubleshooting
7-6
Ramco Innovations
Error code Probable cause
(hexadecimal)
FFFE
FFFD No backup data found in this product
FFFF The type ID of the IO-Link device to
restore does not match
-
supported.
module parameter) settings are not
correct.
IO-Link device) is not installed on this
product.
www.optex-ramco.com
Procedure
If the correct IO-Link device
is currently connected,
overwrite with this setting
register with the vendor ID
and device ID of the currently
connected IO-Link device.
Or, connect the correct IO-
Link device.
If the correct IO-Link device is
currently connected, overwrite
revision ID of the currently
connected IO-Link.
Or, connect the correct IO-
Link device.
from the applicable IO-Link
device to this product.
applicable IO-Link device.
latest version.
Set the correct network
module parameters) based
on the network number and
station number that are
actually connected, write
them to the host PLC, and
then reset the CPU module
of the PLC.
Run IODD_Converter.exe
Installer) to create and install
applicable IO-Link device)
on this product.
(800) 280-6933