Installation Environment Requirements; Moving The Wit Inverter - Growatt WIT 50K-A User Manual

J. Keep the WIT Inverter away from strong interference sources.
K. Ensure that the WIT Inverter is not accessible to children.

5.2 Installation Environment Requirements

A. Though the WIT Inverter is protected to IP66, do not expose it to direct sunlight, rain
and snow. Please refer to the figures below:
B. It is recommended an awning be installed over the WIT Inverter to extend its service life
and avoid performance de-rate. Ensure that a distance of at least 1 m exists between
the frame of the awning and the top of the WIT Inverter and 1.5 m between the sides of
the awning and the WIT Inverter. Please refer to the figures below.
1m
0.52m 0.73m
17
Fig 5.3
1.5m 1.5m
Fig 5.4
C. Do not operate the WIT Inverter in an enclosed or narrow space.
Fig 5.5

5.3 Moving the WIT Inverter

To prevent personal injury caused by a falling inverter, keep balance
Ÿ
and be careful when moving the WIT Inverter as it is heavy.
CAUTION
Plan 1 Hoisting:
1> As shown in Fig 5.6 below, unpack the WIT Inverter (remove the top panel and the
support plates). Then piece the support plates together with the bottom panel. Install
the hoisting rings and pull out the handles. Turn the WIT Inverter upright using the
handles. Run a rope strong enough to bear the inverter through the hoisting rings and
hoist the equipment, and then move the inverter to the installation position;
2> Keep balance when hoisting and moving the WIT Inverter.
support plate
support plate
Fig 5.6 Hoisting the WIT Inverter
Plan 2 Forklift handling:
1> Unpack the WIT Inverter (remove the top panel and the support plates); turn the
equipment upright (place it on a flat ground or a floor support);
2> As shown in Fig 5.7, operate the forklift to insert the tines into the pallet openings to
lift the inverter and then transport it to the installation position. (the fork width
should be less than 0.42 m);
3> Keep balance when lifting and moving the WIT Inverter.
rings
rings
18