Assignable Controller; Expression - Yamaha VL70-m Owner's Manual

Assignable Controller

08 : AC1 CC No.
(08)
• Assignable Controller 1 Control Change Number
• Settings: off ... 95
Assigns the specified control change number as
"Assignable Controller 1". The assigned controller
can then be used to control filter, amplitude, and/or
pitch modulation as specified by the "AC1FilCtrl",
AC1AmpCtrl, and "AC1LFOPMod" parameters.
below. For example, if this parameter is set to "04"
(Foot Controller), then a MIDI foot controller can
be used to control any of the parameters just
mentioned.
09 : AC1FilCtrl
(09)
• Assignable Controller 1 Filter Control
• Settings: -64 ... +63
Determines the degree to which the filter is
affected by Assignable Controller 1 (see "AC1 CC
No.", above). Plus settings cause the cutoff fre-
quency of the filter to increase in response to
increasing controller values, while minus values
cause the filter frequency to decrease in response
to increasing controller values.
10 : AC1AmpCtrl
(10)
• Assignable Controller 1 Amplitude Control
• Settings: -64 ... +63
Determines the degree to which amplitude (vol-
ume) is affected by Assignable Controller 1 (see
"AC1 CC No.", above). Plus settings cause the
54
Controllers & Control Editing
amplitude to increase in response to increasing
controller values, while minus values cause the
amplitude to decrease in response to increasing
controller values.
11 : AC1LFOPMod
(11)
• Assignable Controller 1 LFO Pitch Modulation
• Settings: 000 ... 127
Sets the amount of LFO pitch modulation applied
by Assignable Controller 1 (see "AC1 CC No.",
above). The higher the value the greater the
amount of pitch modulation produced by the
controller. A setting of "000" produces no pitch
modulation.

Expression

12: Exp Mode
(VOICE mode only)
• Expression Mode
• Settings: BC, Vol
Determines whether expression control (MIDI
control change number 11) will function as volume
control or as breath controller. When set to "Vol"
expression will affect volume, but when set to
"BC" expression will produce the same effect as a
breath controller connected to the VL70-m
BREATH jack, affecting the same breath-controlled
parameters.