Repair
10. Insert new component into the fluid hous-
ing. See F
. 12, page 19.
IG
a. Crimp terminal (134) to ground wire
(135). Attach ground wire to fluid hous-
ing with screw (132) and washer (133).
b. Carefully push and pull wires through
hole in the fluid housing. Feed wires
through metal flexible conduit (124).
Secure in fluid housing with set screw
(131).
c. Trim the new wires to 2 in. (50.8 mm)
outside of the metal flexible conduit.
d. As necessary, crimp 24 AWG connector
(129) to RTD wires (122, 123). Crimp 18
AWG connector (28) to ground wire
(135) and to heater wires.
e. Snap wire cover (130) into place.
11. Insert connectors into the male insert
(127). See Wiring Diagram, page 29.
12. Tighten the strain relief (125) to the con-
nector housing (126).
13. Insert male insert (127) into connector
(126) and tighten screw.
20
3A1792A