Table of Contents
Advertisement
2. Attach the table feet (E) Fig. 2, to the bottom of the
motor case, on the same side as the ON/OFF switch (A)
Fig. 7, is located. Align the holes in the table feet (E) Fig.
7, with the holes in the bottom front of the motor case.
Insert a 1/4-20x5/8" hex flange screw through the hole in
the table foot and the hole in the motor case. Thread a
1/4-20 flange nut onto the 1/4-20x5/8" hex flange screw
and tighten securely. Repeat this process for the 7
remaining holes in the table feet and motor case, as
shown in Fig. 7.
3. Attach the casters (D) Fig. 2, to the bottom of the
motor case. Align the holes in the casters (D) Fig. 7, with
the holes in the bottom back of the motor case. Insert a
1/4-20x5/8" hex flange screw through the hole in the
caster and the hole in the motor case. Thread a 1/4-20
flange nut onto the 1/4-20x5/8" hex flange screw and
tighten securely. Repeat this process for the 7 remaining
holes in the casters and motor case.
SIDE MIDDLE BOARDS
1. Lift the motor case so that it is resting on its table feet
and casters.
2. Attach the side middle boards (B) Fig. 2, to the motor
case. Align the holes in the side middle boards (B) Fig. 8,
with the holes in the top of the motor case. Insert a 1/4-
20x5/8" hex flange screw through the hole in the side
middle board and thread into the tapped hole in the top
side of the motor case. Repeat this process for the 5
remaining holes in the side boards and the motor case as
shown in Fig. 8.
BACK MIDDLE BOARD
1. Attach the back middle board (C) Fig. 2, to the motor
case. Align the holes in the back middle board (C) Fig. 9,
with the holes in the motor case. Insert a 1/4-20x5/8"
flange screw through the hole in the back middle board
and thread into the motor case. Repeat this process for
the two remaining holes.
2. Attach the back middle board (C) Fig. 9, to the side
middle boards.Align the holes (D) in the back middle
board (C) Fig. 9, with the holes in the side middle boards
(B). Insert a 1/4-20x5/8" flange screw through the hole in
the back middle board and side middle board, thread a
1/4-20 flange nut onto the flange screw and tighten
securely. Repeat this process for the remaining hole.
BOTTOM MIDDLE BOARD
1. Attach the bottom middle board (H) Fig. 2, to the
front of the motor case. Align the holes in the bottom
middle board (H) Fig. 9, with the holes in the motor case.
Insert a 1/4-20x5/8" flange screw through the hole in the
bottom middle board and thread into the motor case.
Repeat this process for the two remaining holes.
E
D
B
C
H
E
2. Attach the bottom middle board (H) Fig. 9, to the side
middle boards. Align the holes (E) in the bottom middle
board (H) Fig. 9, with the holes in the side middle boards
(B). Insert a 1/4-20x5/8" flange screw through the hole in
the back middle board and side middle board, thread a
1/4-20 flange nut onto the flange screw and tighten
securely. Repeat this process for the remaining hole.
7
A
Fig. 7
B
Fig. 8
D
Fig. 9
B
E
Advertisement
Table of Contents
