Yamaha QY-8 User Manual page 41

4-4. Press [ENTER] to enter the selected end mark or repeat at the
current measure. A dot will appear on the 1 MEASURE bar to
indicate that an end mark or repeat has been entered at that
location.
4-5. Repeat steps 4-2 through 4-4 until all required repeats have been
entered.
Deleting Repeats
To delete a repeat, move the cursor to the dot on the 1 MEASURE
bar corresponding to the change you want to delete, then press the
[ENTER] button. An alternative method is to use the [
j j j j j
[ ] buttons to locate the measure containing the repeat to be
deleted, select the "blank" repeat (indicated by a row of flashing
blocks), and press [ENTER].
• Improperly used repeats (e.g.
mark)will
be ignored.
DETAIL
• You cannot enter repeats within repeats (i.e. "nested" repeats).
The copy and delete functions described in chapter 7 (pages 54,
51) can make the process of creating songs faster and more
efficient.
HINT
Depending on the amount of data you have recorded, it may not
be possible to fully record all 20 available songs. If you run out of
memory during recording, the "MemFull" error message will appear
IMPORTANT
on the display. If this happens use the Clear Song function
described on page 60 to clear unwanted song data. You might also
want to use an optional Yamaha MDF2 MIDI Data Filer to save your
important song data to floppy disk for later loading and use.
5.
Play Back and Check Out Your Song
5-1. Move the cursor to the SONG SELECT pointer ( ) to select the
song select mode.
Creating an Accompaniment
without a corresponding
:||
h h h h h
] and
||:
33