What You Need To Get Started; Inspecting The Matrox Orion Package; Standard Package - Matrox Orion Installation And Hardware Reference

Intellicam Matrox Intellicam is an interactive Windows program that
allows fast camera interfacing and provides interactive access
to all the acquisition features of your Matrox board. Matrox
Intellicam can be used to fine tune acquisition settings on your
Matrox Orion board. Intellicam is included with both MIL and
MIL-Lite.

What you need to get started

To begin using Matrox Orion, you need the following:
Computer with an empty AGP or PCI expansion slot and a
Pentium-II-class processor or better for the AGP version, or
a Pentium-class processor or better for the PCI version. Note
that the AGP version of the Matrox Orion supports AGP 1X
on chipsets such as Intel 440LX, and AGP 2X on chipsets such
as Intel 440BX, 820, and 840.
Windows: See your software package for supported
environments and RAM requirements.
A CD drive, and a hard disk or network drive on which to
install the Matrox Orion software.

Inspecting the Matrox Orion package

When you unpack your Matrox Orion package, you should
check its contents. Note that optional parts will only be included
if ordered. If something is missing or damaged, contact your
Matrox representative.

Standard package

If you ordered Matrox Orion, you should receive the following
items:
The Matrox Orion board, the expanded video I/O adapter
bracket, and the flat ribbon cable.
The Matrox Orion Installation and Hardware Reference
manual (this document).
What you need to get started 11