Matrox Orion Installation And Hardware Reference page 28

28 Chapter 4: Matrox Display Properties and Matrox PowerDesk
Windows NT 4.0 Under Windows NT 4.0. When using a Plug-and-Play (DDC)
monitor, Windows should automatically use the correct settings
for your monitor. To make sure the correct monitor is selected
in Windows:
1. Click on the Monitor property page of the Matrox Display
Properties utility.
2. Make sure the Plug-and-Play (DDC) monitor option is
selected. If so, the Matrox display driver automatically uses
the correct settings for your monitor. If not, select the
Plug-and-Play (DDC) monitor option, and then click on
Apply.
If you want to customize your Windows monitor settings, click
on the Settings property page and follow on-screen
instructions.
If you want to install a monitor other than a Plug-and-Play
(DDC) monitor, click on the Monitor property page. Select the
Matrox monitor option and follow on-screen instructions.
Other considerations
If you are using BNC connectors with a Plug-and-Play
monitor, the Plug-and-Play feature of your monitor cannot be
used. To use the Plug-and-Play feature of your monitor, use
the 15-pin connector at the back of your monitor instead of
the BNC connectors.
In Windows 2000, Matrox monitor settings are based on
Windows monitor settings. If you change your Windows
monitor settings, you might have to reselect or readjust your
Matrox monitor settings.
For more information on Windows monitor settings, see
Windows documentation.