Regulatory Compliance - Matrox CronosPlus Installation And Hardware Reference

Regulatory compliance

FCC Compliance Statement
Remark for the Matrox hardware products supported by this guide
These devices have been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment causes harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures: • Reorient or relocate the receiving antenna • Increase the
separation between the equipment and receiver • Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected • Consult the dealer or an experienced radio/TV
technician for help.
WARNING
Changes or modifications to this unit not expressly approved by the party responsible for the compliance
could void the user's authority to operate this equipment. The use of shielded cables for connection of
the monitor to the card is required to meet FCC requirements.
Declaration of conformity of a Class B digital device
according to the FCC rules
We, the Responsible Party
Matrox International Corporation, 625 State Route 3, Unit B, Plattsburg, NY 12901-6530
Telephone: (514) 822-6000 (x2026) • Attention: Conformity Group
Declaration
The Matrox hardware products supported by this guide comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) these devices may not cause harmful
interference, and (2) these devices must accept any interference received, including interference that may
cause undesired operation. Any question regarding this declaration should be forwarded to the above
coordinates.