Advertisement
3.
Connect the positive (red) cable to the battery.
4.
Connect the ground (black) cable to the battery.
5.
Make sure the engine oil level is correct.
6.
Check the operation of the accelerator cable and adjust if necessary:
A.
At the throttle cable housing, loosen the forward jam nut and tighten the rear jam nut to increase the
low idle
(Figure
1. Throttle-cable housing
2. Jam nuts
B.
Test the high idle with a tachometer:
i.
Ensure that the shift lever is in the N
ii.
Start the engine.
iii.
Fully press the accelerator pedal and measure the engine speed with a tachometer; the engine
speed should be between 3,650 to 3,750 rpm. If it is not, shut off the engine and adjust the
cable jam nuts.
Important:
idle is between 3,650 to 3,750 rpm.
13).
Do not lower the high idle. Test with a tachometer to ensure that the high
Figure 13
3. Throttle lever
position.
EUTRAL
9
g229954
Advertisement
