Yamaha MU128 Sound List & Midi Data page 37

MIDI data format
0mmmmmmm MMH
0lllllll LLH
11110111 F7H
2.4 Dump request
This message requests transmission of a specific block of parameter
values.
The output is the same as the bulk dump format.
2.4.1 XG dump request
This message requests transmission of all parameters of the
specified block of XG parameters.
The output is the same as the format of XG bulk dump (refer
to 2.2.1).
11110000 F0H
01000011 43H
0010nnnn 2NH
01001100 4CH
0ggggggg GGH
0mmmmmmm MMH
0lllllll LLH
11110111 F7H
Address is valid only when the beginning of the block has
been specified.
Reception/transmission of Dump Request cannot be turned
off by MIDI switches other than Exclusive = off.
2.4.2 MU128 native dump request (1)
This message requests transmission of all parameters of the
specified block of MU128 native parameters.
The output is in the same format as an MU128 native bulk
dump (refer to 2.2.2).
11110000 F0H
01000011 43H
0010nnnn 2NH
01001001 49H
0ggggggg GGH
0mmmmmmm MMH
0lllllll LLH
11110111 F7H
Details are the same as for 2.4.1 XG Bulk Dump Request.
2.4.3 MU128 native dump request (2)
This message requests transmission of all parameter values
of the specified MU128 native parameter block.
The output is in the format of MU128 Native Bulk Dump
(refer to 2.2.3).
11110000 F0H
01000011 43H
0010nnnn 2NH
01011001 59H
0ggggggg GGH
0mmmmmmm MMH
0lllllll LLH
11110111 F7H
38
Address Mid
Address Low
End of Exclusive
Exclusive status
YAMAHA ID
N:device Number
Model ID
Address High
Address Mid
Address Low
End of Exclusive
Exclusive status
YAMAHA ID
N:Device Number
Model ID
Address High
Address Mid
Address Low
End of Exclusive
Exclusive status
YAMAHA ID
N:Device Number
Model ID
Address High
Address Mid
Address Low
End of Exclusive
MU128 MIDI
Details are the same as for 2.4.1 XG Bulk Dump Request.
3. Realtime messages
3.1 Active sensing
a) Transmission
not transmitted.
b) Receive
Once FE has been received, failure to receive any MIDI
message for an interval longer than approximately 300
msec will cause processing to be performed as if ALL
SOUND OFF, ALL NOTE OFF, and RESET ALL
CONTROLLERS messages were received, and the unit
will reset to a condition in which FE was never received.