Troubleshooting
Clear error conditions
If an error occurs during scanning, the power/scan button LED flashes red. Refer to the
following table to eliminate error situations.
The number of
times the red
Description
LED flashes
4 (continued)
Paper jam
6 (continued)
Cover open
If the battery charge is below 25%, the battery LED flashes red. Recharge the
battery to avoid possible incomplete scanned images or other operating
problems.
Remove a paper jam
Open the cover by holding the scanner with one thumb on the feeder and the other
1
on the cover. Press your thumb carefully and firmly against the feeder, then lift the
cover. The top of the scanner now detaches from the bottom.
How to restore
Remove the paper and try again.
The red LED will not stop flashing
unless the paper is removed.
Close the cover and try again. The
red LED will not stop flashing
unless the cover has been closed.
Page 43