Inserting The Wire Shelf And Other Accessories; First Time Use - Whirlpool OMK58CU1SB Owner's Manual

ACCESSORIES
WIRE SHELF
Use to cook food or as a
support for pans, cake tins
and other ovenproof items of
cookware.
* Available only on certain models
The number and the type of accessories may vary depending on which model is purchased.
Other accessories can be purchased separately from the After-sales Service.
INSERTING THE WIRE SHELF AND OTHER
ACCESSORIES
Insert the wire shelf onto the level you require by
holding it tilted slightly upwards and resting the
raised rear side (pointing upwards) down first.
SLIDING RUNNERS AND SHELF GUIDES
Before using the oven remove the protective tape
[a] and then remove the protective foil [b] from the
sliding runners.
REMOVING THE SLIDING RUNNERS [c]
Pull the lower part of the sliding runner to uncouple
the lower hooks (1) and pull the the sliding runners
upwards, removing them from the upper hooks (2).
REFITTING THE SLIDING RUNNERS [d]
Hook the upper hooks on the shelf guides (1) then
press the lower part of the sliding runners against the
shelf guides, until the lower hooks are clicking (2).

FIRST TIME USE

1. SETTING THE TIME
You will need to set the time when you switch on the
appliance for the first time: Press
the two digits for the hour start flashing on the display.
Use or to set the hour and press
The two digits for the minutes will start flashing.
Use or to set the minutes and press
Please note: When the
2
DRIP TRAY *
Use as an oven tray
for cooking meat, fish,
vegetables, focaccia, etc. or
position underneath the wire
shelf to collect cooking juices.
until the
to confirm.
to confirm.
icon is flashing, for example following
BAKING TRAY *
Use for cooking all bread and
pastry products, but also for
roasts, fish en papillotte, etc.
Then slide it horizontally along the runners as far as
possible.
• Other accessories, like the baking tray, are to be
inserted horizontally, letting them slide on the runners.
2
1
REMOVING AND REFITTING THE SHELF GUIDES
1. To remove the shelf guides, firmly grip the external
part of the guide, and pull it towards you to extract
the support and the two internal pins from the
lodging.
2. To reposition the shelf guides, position them near
the cavity and initially insert the two pins into their
lodgings. Next, position the external part near its
lodging, insert the support, and firmly press towards
the wall of the cavity to make sure the shelf guide is
properly secured.
lengthy power outages, you will need to reset the time.
2. HEAT THE OVEN
icon and
A new oven may release odours that have been left
behind during manufacturing: this is completely
normal. Before starting to cook food, we therefore
recommend heating the oven with it empty in
order to remove any possible odours. Remove any
protective cardboard or transparent film from the
oven and remove any accessories from inside it.
Heat the oven to 250 °C for about one hour.
The oven must be empty during this time.
Please note: It is advisable to air the room after using the
appliance for the first time.
SLIDING RUNNERS *
To facilitate inserting or
removing accessories.
1
2
[c] [d]