Yealink CP935W Manual

Yealink CP935W Manual

Phone dect and wifi configuration
Hide thumbs Also See for CP935W:

Advertisement

Yealink CP935W Phone DECT and WiFi Configuration
Objective
This article will show you how to configure your Yealink CP935W Wireless Conference Phone for operation as either a
DECT or WiFi device.
The following topics are covered:

DECT Setup

Applies To
• Yealink CP935W
• Yealink W70B Base Station
• DECT Configuration
• WiFi Configuration
Procedures
DECT Setup
To configure the phone for DECT operation and then pair it with an operational Yealink W70B Base Station:
1. Power up the CP935W unit.
2. At the Select mode screen, select Dect Mode and press OK. The device will reboot.
https://support.8x8.com/devices-accessories/phones/yealink/Yealink_CP935W_Phone_DECT_and_WiFi_Configuration
Updated: Fri, 09 Feb 2024 21:08:10 GMT
Powered by
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CP935W and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Yealink CP935W

  • Page 1 Yealink CP935W Phone DECT and WiFi Configuration Objective This article will show you how to configure your Yealink CP935W Wireless Conference Phone for operation as either a DECT or WiFi device. The following topics are covered: • DECT Setup •...
  • Page 2 3. At the Unregistered prompt, select Reg. Pair the CP935W with a Yealink W70B Base Station Follow these steps to place your W70B base station into registration mode, and then register the CP935W phone with it: Enable Registration Mode on the W70B Base Station •...
  • Page 3 Register the CP935W to the W70B Base Station 1. After pressing the Reg option on the CP935W, it will search for a base station that is currently in registration mode. 2. After the phone is registered successfully, it will display the prompt Handset Subscribed and Base NO (the last 4 characters of the connected Base’s MAC address).
  • Page 4 If not, follow the steps in this article to configure each mode. Factory Reset The CP935W can be reset to factory defaults from either DECT mode or WiFi mode. DECT Mode Reset 1. From the main screen press ...More.
  • Page 5 7. In web interface navigate to Settings > Upgrade. 8. In Reset, click Reset to Factory Settings. 9. Click OK to complete the operation. https://support.8x8.com/devices-accessories/phones/yealink/Yealink_CP935W_Phone_DECT_and_WiFi_Configuration Updated: Fri, 09 Feb 2024 21:08:10 GMT Powered by...

Table of Contents