Getting Started - TeleCare24 Chiptech GO User Manual

Setting up your Chiptech GO™

Getting started

1.Place the charging cradle down on a flat surface near a power source (such as
your bedside table). Now take the cable and connect the smaller end to the
back of the cradle. Now, connect the larger end to the 3-pin plug. Finally, insert
the 3-pin plug into your power source - making sure it is switched on.
2. Your Chiptech GO™ will be in Flight Mode when it arrives. This is to prevent
the device from accidentally sending alert calls during shipping. To disable Flight
Mode place the Chiptech GO™ on charge.
3. To charge your Chiptech GO™ , simply place it down on the cradle with the
'walking person' symbol facing up at you. When it is seated correctly, the LED
lights around the cradle will turn
it is fully charged, the LED light around the Chiptech GO™ will turn green.
4. Once the device is fully charged (the lights around the device will turn green),
you need to perform a System Check.
5. Now you need to place a test call to check that your equipment is working
See Placing a test call / How to call for help.
correctly.
Make sure to charge your Chiptech GO™ after every call.
blue - indicating that it is now charging. When
See Performing a System Check.