Charging Mobile Phones And Tablets; Switching On The Lights; Faqs; Troubleshooting - ULTIMATE SPEED UPBS 8000 A1 Operation And Safety Notes

 Charging mobile phones
and tablets
Press the power switch
†
Connect your mobile phone or tablet's USB
†
power cable to the USB output (5 V
3 and then to your mobile phone or tablet.
Note: Charging is not possible if the power
pack is already fully charged.
 Switching on the lights
When switching on the lights, hold down the
†
power button 4
Press the power button
†
strobe mode.
Press the power button
†
the SOS signal.
Press the power button
†
the light.
CAUTION! Do not look directly at the LED
lights as this can damage your eyes.
Note: It is not possible to turn on the light
while the power pack is charging.

FAQs


Q: How can I switch the device off?
A: The device automatically switches off after
20 seconds of non-use.
Q: How long does it take to fully charge
a mobile phone with the device?
A: With a battery power of 2500 mAh:
1A (2–3 hours) / 2A (1–2 hours)
Q: How often can a vehicle be started
with a fully loaded device?
A: approx. 20 times (engine capacity ≤ 2.0 l)
Q: How long does the device's
battery last?
A: 3–6 months. However, we recommend
charging the battery every 1–2 months.
290925_uls_Powerbank_content_Block_5_IT_GB_DE.indd 21
Set up / FAQs / Troubleshooting / Cleaning / Storage
4
.
/ 1 A/2 A)
for 3 seconds.
4
again to switch on
4
again to switch on
4 again to switch off

Troubleshooting



= Problem

= Cause

= Solution

The jump start aid is not fully charged,
although all 4 indicator lights
permanently lit.

It is 60% charged after a long period out of
use or in storage.

Disconnect the charger
The correct number of LEDs are glowing.

There is no response to pressing the
power button 4 .

The jump start aid's low voltage protection is
activated.

Connect the charger 9
(5 V / 1 A) 2.

Cleaning


You must not splash the
device with water or place it in water.
There is a risk of injury due to electric
shock if moisture enters the device.
Do not use cleaners or solvents. These could
„
damage the equipment beyond repair.
Keep the casing of the device clean.
†
Use a damp cloth or brush to clean.
†

Storage


Keep the device in a dry location and out of
†
the reach of children.
5 are
9
and reconnect it.
to the charging output
GB 21
05.07.17 17:20