Table of Contents
Advertisement
Available languages
Available languages
Set up
Charging the jump start aid
Plug in the power pack with vehicle start-up
†
9
aid
.
Plug the power supply adaptor cable
†
the charging port (5 V
power pack with vehicle start-up aid.
Function
1. Connect the
jumper cable
8
of the jump
start aid to the
car's startup aid
output
6
of the
charger
9
.
2. First connect the
red clamp A to
the positive pole
of the vehicle
battery and
then connect the
black battery
clamp B to the
negative pole
(see picture 1).
3. Starting up
the vehicle
1
As soon as the vehicle starts,
remove the jumper cable
start aid within 30 seconds and disconnect
20
GB
290925_uls_Powerbank_content_Block_5_IT_GB_DE.indd 20
12
into
2
/1A)
of the
LEDs
LED
11
on the jumper cable
glows red continuously
8
10
11
LEDs
,
flash red and
green
11
LED
flashes red, a short
warning signal sounds
LED
11
flashes red, a contin-
uous warning signal sounds
11
LED
flashes red once, a
continuous warning signal
sounds, followed by two
short warning beeps
11
The red
and green LED
flash alternately.
10
After 1–2 seconds only the
green LED glows
10
B
A
2.
1.
8
from the jump
Charging the 12 V vehicle
battery
Make sure that the charger
†
3 illuminated indicator lights
Meaning/Error
The voltage detected
in the charger is not
sufficient to charge the
car battery
Charger ready
The temperature is
too high, possibly due
to several jump start
attempts
Battery clamps A and
B are the wrong way
round.
It is caused by a
shortcircuit or the
battery is leaking
The connection is
correct
firstly the black battery clamp and then the red
clamp from the battery poles. Otherwise
dangerous situations can arise!
Leave the vehicle engine running.
†
Note: The button on the LED box
the jumper cable has no effect and must not
be used. It is only used for troubleshooting
purposes during the manufacture of the device.
9
has no less than
5
.
Solution
Charge the charger.
Carry on to step 2
Disconnect the black
battery clamp first
and then the red
clamp from the
battery poles. Start
again from step 1
Carry on to step 3
13
from
05.07.17 17:20
Advertisement
Chapters
Table of Contents
