Kenmore 911.95402000 Use & Care Manual page 3

IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Read all instructions before using this appliance. When using gas
or electrical appliances, basic safety precautions should be followed,
including the following:
• All Ranges Can Tip
Injury to Persons
Could Result
:. Install Anti-Tip
Device Packed
With Range
See Installation
Instructions
These ANTI-TIP bracket installation
instructions are for wood or concrete
floors and walls Any other type of
construction may require special
installation techniques to provide
adequate fastening of the ANTI-TIP
bracket to the floor and walt
The use of this bracket does not
prevent tipping of the range when
bracket is not properly installed
NOTE: The installation of the
ANTI-TIP bracket must meet all
local codes for securing appliance
Step 1
Locating the bracket
A. Locate the bracket against the
rear wall and either the right or left
cabinet. If the countertop
overhangs the cabinet, offset the
bracket from the cabinet by the
amount of overhang tf there is no
adjacent cabinet, position the edge
of the bracket at the desired
location of the range side panel
B. Use the bracket as a template
and mark 2 hole positions on the
walt and 2 hole positions on the
floor Use either the wood or
concrete floor set of positions,
depending on your floor type.
See Fig, 1,
Adjacent Cabinet or
Final Location of Range
Side Panel
Wall
Wood Holes
Floor Holes
Bracket
Side
k
Rear
Leveling Leg
Concrete
Floor
Holes
Fig, 1
continued on next page
3