Table of Contents
Advertisement
User Manual
CFV 100C
2. Connect the USB-C port of the camera with the provided 30W USB-C charger using the
USB-C to USB-C cable and connect the charger to a power outlet (100-220V, 50-60Hz).
It takes approximately two hours to fully charge the battery using the provided charger.
• It is recommended to use the provided charger or the Hasselblad Battery Charging Hub
(not included) to charge the battery. Otherwise, use an FCC or CE certified USB PD charger.
• DO NOT put batteries in a microwave oven or a pressurized container.
• DO NOT charge the battery near flammable materials or on flammable surfaces (e.g.,
carpet or wood).
• Disconnect the charger when not in use. Examine the charger regularly for damage to the
cord, plug, enclosure, or other parts. Never use a damaged charger.
• Remove the battery from the camera if you intend to store the camera for an extended
period. Discharge the battery to a power level between 30% and 60% and place the
battery at room temperature. The battery power level can be checked through the rear
touch screen of the camera.
• Fully charge and discharge the battery at least once every three months to maintain
battery health.
Charging Indicators
When charging the digital back with its power off, the status LED on the digital back will
blink to display the current charging status. Refer to the table below.
Blinking Pattern
Blinks yellow once
×1
Blinks yellow twice
×2
Blinks yellow three times
×3
Blinks yellow four times
×4
CONTENTS
Battery Level
0-25%
26-50%
51-75%
76-100%
20
Advertisement
Table of Contents
