GUBI Stemlite Assembly Instructions

C A R E I N S T R U C T I O N S
Daily cleaning can be done by wiping the frame with a clean dry cloth.
Should the surface need more attention this can be cleaned with water
and a light detergent or soap applied with a damp cloth. Wipe after with
a clean dry cloth. Avoid any abrasive materials.
T R O U B L E S H O O T I N G
If lamp does not light, turn off the power. Check the bulb for a broken
filament. Replace bulb if necessary, then turn it on. If the lamp still
does not light, please contact customer service at the local dealer. If
the external flexible cable or cord of this lamp is damaged, it must be
replaced by a qualified electrician in order to avoid a hazard.
T E C H N I C A L I N F O R M A T I O N

Recommended light source:

Stemlite Table H42 and H70: E27, 470 Lumen (40W Halogen, ~4-5W LED).
Stemlite Floor H110 and H150: E27, 810 Lumen (60W Halogen, ~8-9W LED).
With LED you can increase the light output up to 1530 Lumen (~13-16W).
Turn power off when changing light bulb. Isolation class II. The lamp is not approved
for outdoor use or use in damp/wet rooms (IP20)
For enquiries contact GUBI A/S - CVR: 17940384
Klubiensvej 7-9. 2150 Nordhavn. Copenhagen, Denmark
T +45 69 15 60 60 – order@gubi.com
GUBI.COM
118-20-001-03 Assembly Instructions Stemlite Table and Floor Lamps EU.
AS S E MBLY I N ST RU C TIO N S
fo r
Stemlite Table & Floor Lamps