GUBI 9209 Assembly Instructions

C A R E I N S T R U C T I O N S
Daily cleaning can be done by wiping the frame with a clean dry cloth.
Should the surface need more attention this can be cleaned with water
and a light detergent or soap applied with a damp cloth. Wipe after with
a clean dry cloth. Avoid any abrasive materials.
T R O U B L E S H O O T I N G
If lamp does not light, turn off the power. Check the bulb for a broken
filament. Replace bulb if necessary, then turn it on. If the lamp still
does not light, please contact customer service at the local dealer. If
the external flexible cable or cord of this lamp is damaged, it must be
replaced by a qualified electrician in order to avoid a hazard.
T E C H N I C A L I N F O R M A T I O N
Light sources: E27, Max. 6W LED, 810 Lumen.
Turn power off when changing light bulb. Isolation class II. The lamp is
not approved for outdoor use or use in damp/wet rooms (IP20).
S A F E T Y I N S T R U C T I O N S
CAUTION: Keep lamp away from curtains, bedding linens, and any
other flammable materials. Do not look directly at lighted bulb. Turn off
/ unplug and allow lamp to cool before replacing bulb, cleaning or other
maintenance. Do not use in the bathroom or damp places.
Do not exceed recommended wattage.
For enquiries contact GUBI A/S - CVR: 17940384
Orientkaj 18-20. 2150 Nordhavn. Copenhagen, Denmark
T +45 69 15 60 60 – order@gubi.com
GUBI.COM
195-20-001-01 9209 Table Lamp Assembly Instructions.
AS S E MBLY I N ST RU C TIO N S
fo r
9209 Table Lamp