System Requirements For 01X/Software; Software Installation - Yamaha 01X Software Installation Manual

System Requirements for 01X/Software

The system requirements below are necessary for using the included
software.
• The system requirements below may differ slightly depending on the particular oper-
ating system.
• For details on minimum requirements for each DAW software, refer to the respective
owner's manual.
01X (including the requirements for mLAN Driver/mLAN Tools)
These are the total system requirements, including the audio
sequencer,mLAN Driver/mLAN Tools and the plug-in effects.
OS : Mac OS 9.2 (Mac OS X and Mac Classic environment are
not supported.)
Computer : System having a built-in S400 (400 Mbps) FireWire termi-
nal. (*1)
･ Recommended system (*2)
Computer : G4/G3 signal processor 900 MHz (or higher)
Available Memory : 512 MB or more (Virtual memory must be turned
off)
Hard Disk : Free disk space of 175 MB or more; high-speed
hard disk
･ Minimum system requirements (*3)
Computer : G4 dual processor 450 MHz or G4/G3 single pro-
cessor 700 MHz (or higher)
Available Memory : 320 MB or more (Virtual memory must be turned
off)
Hard Disk : Free disk space of 175 MB or more; high-speed
hard disk
*1 The computer must have an IEEE 1394 (FireWire) or i.Link terminal. If
there is no terminal, install an IEEE 1394 interface card (PCI or PCMCIA).
For more details on system requirements and recommended PCI or PCM-
CIA cards, see
http://www.yamahasynth.com
*2 The system requirements listed here apply when using the included soft-
ware and when playing/recording audio/MIDI data detailed below on stan-
dard sequencer software. This may differ depending the particular
sequencer software you are using.
Frequency/resolution: 44.1 kHz/24 bit
Audio Driver: 24 in/18 out (active)
MIDI Driver: 4 in/4 out
(including MIDI Remote Control/Automation)
Audio playback tracks: 12
Audio recording tracks: 2
MIDI playback tracks: 16
MIDI Remote Control/Automation
Send effects (plug-in): 2
Insert effects (plug-in): 10
Plug-in synthesizer: 3
Latency: 5 msec or less
*3 The system requirements listed here apply when using the included soft-
ware and when playing audio/MIDI data detailed below on standard
sequencer software. This may differ depending the particular sequencer
software you are using.
Frequency/resolution: 44.1 kHz/16 bit
Audio Driver: 8 in/2 out (active)
MIDI Driver: 1 in/1 out (MIDI Remote Control/Automation)
Audio playback tracks: 12
MIDI Remote Control/Automation
Send effects (plug-in): 2
Insert effects (plug-in): 6
Plug-in synthesizer: none
Latency: about 90 msec
18
TOOLS for 01X/Plug-in Effect Installation Guide
Studio Manager
OS : Mac OS 8.6 through 9.2.2 (Mac OS X and Mac Classic
environment are not supported.)
Computer : 233 MHz or high; G3
Available Memory : 80 MB or more (Virtual memory must be turned off)
Hard Disk : Free disk space of 7 MB or more
Display : 1024 x 768 dots, 256 colors or more
(1280 x 1024 dots, High Color16 bit is recommended)
Plug-in Effect
OS : Mac OS 8.6 through 9.2
Mac OS X 10.2
• When using a PowerBook under battery power, go Apple menu
[Energy Saver] [Advanced Settings] (Settings for: Battery), and remove the
check from the "Allow processor cycling."

Software Installation

For instructions on how to install the software other than one
referred to below, see page 17 in the section "CD-ROM Contents."
Acrobat Reader
In order to view the electronic (PDF) manuals included with each
application,you'll need to install Acrobat Reader.
1
Double-click on the "Acroread_" folder. Three different language folders
will be displayed: English, German, French and Japanese.
2
Select the language you want to use and double-click on its folder.
"Reader Installer" will be displayed.
The Installer name may differ depending on the language you select.
3
Double-click on the "Reader Installer."
Acrobat Reader Setup Dialog will be displayed.
4
Execute the installation by following the directions appearing on the
screen.
After installation is complete, the Acrobat folder appears on your com-
puter (in Hard Disk, as the default).
For information on using the Acrobat Reader, refer to the Reader Guide in
the Help menu.
[Control Panel]