Related Manuals for Maxtor MTC08 Series
Summary of Contents for Maxtor MTC08 Series
- Page 1 INSTALLATION MANUAL MTC08 series We reserves the right to improve the product's appearance, size and technology without prior notice. All products sizes and colors are subject to the actual product...
-
Page 2: Tools Required For Installation
Preparation before installation Product size chart PRECAUTIONS All vanities must be installed by a fully qualified plumber. Vanities and tops must be installed onto finished surfaces. It is imperative that all bathroom installations are ventilated to meet standards. Failure to provide ventilation that meets these standards will void the manufacturer's warranty. -
Page 3: Solid Wall
Installation of different walls WOODEN WALL PREPARATION Make sure the vanity and LED mirror (or Medicine cabinet) be mounted on the reinforcement plate. 2''x4'' [25x100mm] Wood reinforcement MTC08100 VANITY SIDE MT02100R MWC08100 35'' [890mm] Suggested 2"x4" Height [50x100mm] Wood 13-3/4'' Reinforcement [350mm] Suggested... -
Page 4: Cabinet Installation
Specication & Installation Guide CABINET INSTALLATION Recommended Wall STEP 1 VanityMounting Height Locate cabinet & mark location 33-1/2'' [850mm] Suggested Helght 13-3/4'' [350mm] STEP 2 STEP 3 Wall positioning perforation & Wall plug. Tighten the screws,adjust level. 34-1/4'' Φ10mm Drill Bit [870mm] M6 PA screws Screws cushion... -
Page 5: Electric Connections
ELECTRIC CONNECTIONS STEP 4 STEP 5 Adjust level. Twist screw cover. ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENCED ELECTRICIAN WARNING: Shut off power before wiring the mirror. WARNING: An Electrical option mirror must be wired to a 20 Amp GFl(Ground Fault Interrupter) protected circuit when used in bathrooms andall other locations required by the National Electric Code. -
Page 6: Faucet Installation
MIRROR MOUNT FAUCET INSTALLATION For first time install, flush the pipes first byopen the angel valve to run 60s. STEP 1 STEP 2 STEP 1 STEP 2 Placment Support location Clean and wipe the countertop and check Remove the mounting hardware from Select the desired position of the mirror. -
Page 7: Drawer Assembly
POP-UP WASTE INSTALLATION DRAWER ASSEMBLY STEP 1 lnstall Pop-up Waste with over flow Lay the drawer bottom onto the slide then push thedrawer into the cabinet. Removal with Locking Device For removal, hold the handle and pull out the drawer. STEP 2 Connect the drain pipe Drawer up &... -
Page 8: Door Remove
DOOR INSTALL HINGE ADJUSTMENT AND REMOVAL INSTRUCTION PIVOT-PRO side adjustment Side adjustment of the door is made by using the indicated screw. PIVOT-PRO Depth Adjustment Depth adjustment is made without loosening any screw.The door can be moved in or outby rotating the cam adjuster on the hinge arm. Snap-on cam-adjustable DOOR REMOVE... -
Page 9: Troubleshooting
Cleaning and Warranty General Cleaning Aquas Bath products are made from materials or sourced specifically for bathroom and laundry spaces. Our vanities and cabinetry are designed to be water resistant, not waterproof. Care must be taken to immediately TROUBLE SHOOTING dry spillage as well as ventilate your bathroom to eliminate moisture build up or humidity which will lead to deterioration of materials and is not covered by warranty.