Related Manuals for Maxtor MTC11 Series
Summary of Contents for Maxtor MTC11 Series
- Page 1 INSTALLATION MANUAL MTC11 series We reserves the right to improve the product's appearance, size and technology without prior notice. All products sizes and colors are subject to the actual product...
- Page 2 Preparation before installation Installation of different walls WOODEN WALL PREPARATION Make sure the vanity and LED mirror (or Medicine cabinet) be mounted on the reinforcement plate. PRECAUTIONS 2''x4'' [25x100mm] Wood reinforcement All vanities must be installed by a fully qualified plumber. Vanities and tops must be installed onto finished surfaces.
-
Page 3: Cabinet Installation
Specication & Installation Guide CABINET INSTALLATION STEP 1 Recommended Wall VanityMounting Height Locate cabinet & mark location 33-1/2'' [850mm] Suggested Height 13-3/4'' [350mm] STEP 2 STEP 3 Wall positioning perforation & Wall plug. Tighten the screws,adjust level. 34-1/4'' [870mm] Φ10mm Drill Bit M6 PA screws Screws cushion IMPORTANT! - Page 4 SIDE CABINET INSTALLATION STEP 4 STEP 5 STEP 1 STEP 2 Adjust level. Twist screw cover. Align with the bottom of the Mark the location of the bracket. bathroom cabinet. STEP 6 STEP 7 STEP 3 STEP 4 Intall the basin and glue. Fix the bracket with screws x 3pcs.
-
Page 5: Electric Connections
MIRROR MOUNT ELECTRIC CONNECTIONS STEP 1 STEP 2 ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENCED ELECTRICIAN Placment Support location WARNING: Shut off power before wiring the mirror. Select the desired position of the mirror. Measure the center of the holes and mark the Level and mark the location. -
Page 6: Faucet Installation
FAUCET INSTALLATION POP-UP WASTE INSTALLATION For first time install, flush the pipes first byopen the angel valve to run 60s. STEP 1 STEP 2 STEP 1 Clean and wipe the countertop and check if it is Remove the mounting hardware from level. -
Page 7: Drawer Assembly
DRAWER ASSEMBLY HINGE ADJUSTMENT AND REMOVAL INSTRUCTION PIVOT-PRO side adjustment Side adjustment of the door is made by using the indicated screw. Lay the drawer bottom onto the slide then push thedrawer into the cabinet. PIVOT-PRO Depth Adjustment Removal with Locking Device Depth adjustment is made without loosening any screw.The door can be moved in or outby rotating the cam adjuster on the hinge arm. -
Page 8: Troubleshooting
TROUBLE SHOOTING DOOR INSTALL What happens if my soft close drawer is not closing properly? It means that your soft close drawer is not engaged correctly. Follow the instructions on page 03 to re-engage the soft close mechanism. Why is my soft close drawer making a noise on closing, and not closing smoothly? If the release tabs on the drawer are not lifted properly, then this may cause the cog to strip on the soft close mechanism. -
Page 9: Cleaning And Warranty
Cleaning and Warranty General Cleaning Aquas Bath products are made from materials or sourced specifically for bathroom and laundry spaces. Our vanities and cabinetry are designed to be water resistant, not waterproof. Care must be taken to immediately dry spillage as well as ventilate your bathroom to eliminate moisture build up or humidity which will lead to deterioration of materials and is not covered by warranty.