Table of Contents
Advertisement
Preparation before
PRECAUTIONS
All vanities must be installed by a fully qualified plumber.
Vanities and tops must be installed onto finished surfaces.
It is imperative that all bathroom installations are ventilated to meet standards.
Failure to provide ventilation that meets these standards will void the
manufacturer's warranty.
It is important that the product is unpacked and inspected for any damage,
defects, and that the product supplied is correct. If any of the above is
apparent,
Do not proceed with this installation and contact the water
bath immediately.
TOOLS REQUIRED FOR INSTALLATION
Φ10mm & Φ6mm
Electric/Battery Drill
Drill Bit
Kitchen & Bathroom
Pencil
Non-Acidic Silicone
SCREW (x10)
WALL PLUG (x10) WIRE CONNECTOR (x4)
2
installation
Tape Measure (3m-5m)
Spirit Level
Screw Driver
Hammer
Stud (x2）
Nut (x2）
Product size chart
MTC08060
VANITY SIDE
MTC08070
VANITY SIDE
MTC08080
VANITY SIDE
MT02060R
MWC08060
MT02070R
MWC08070
MT02080R
MWC08080
3
Advertisement
Table of Contents
