Advertisement
Insert/Replace Batteries in the Remote Control
1.
Open the battery compartment on the underside of the remote control.
2.
Insert x2 AAA/R03 1.5V batteries (not provided). Pay attention to the correct
polarity (see inside the battery compartment).
3.
Close the battery compartment.
Note:
If the remote control is not going to be used for a long period of time (more than a
month), remove the battery.
Power On/Standby
Note:
Before connecting to power, ensure that the power supply voltage corresponds to the
voltage printed on the back or the underside of the soundbar.
1.
Insert the DC end of the AC-DC power adaptor into the DC IN port on the bottom
of the soundbar, then connect the AC-DC adapter to an electrical outlet.
2.
Press and hold the
the remote control to switch the sound bar on. The last used mode will illuminate
on the display.
3.
Press and hold the
the remote control to turn off the soundbar and enter standby mode.
10
/ SOURCE button on the soundbar or press the
/ SOURCE button on the soundbar or press the
button on
button on
Advertisement
