Page 1
Item #: ILSLB6B Assembly Instructions Please visit our website for the most current instructions, assembly tips, to report damage or request parts.www.walkeredison.com Revised /2023 - V1 Copyright 2018, by Walker Edison Furniture Co., LLC, All rights reserved.
Parts List Part# Description Part# Description Central Foot Upper Rail / Lower Slat (HEADBOARD) Union Support Middle Slat (HEADBOARD) Footboard Right Post Upper Short Slat Footboard Left Post Upper Long Slat Headboard Left Post Central Support Headboard Right Post Slat Set Right Side Rail Left side rail Head/Foot Rail...
Page 5
Step 1 Ø10*40mm Insert wood dowel (C) into parts ( 20 21 22 23 24 25 and ( Step 2 Step 2 Ø * 7 10 Hex Key HEADBOARD Secure part to parts 23 22 with screw (E) using Hex Key (J). Align dowels part 24 to holes in part 18.
Page 6
Step 3 Ø * 7 10 Hex Key Secure part to parts 23 22 with screw (E) using Hex Key (J). Align dowels part 24 to holes in part 18. Step 4 Ø * 4 25 Pre Drilled Holes HEADBOARD...
Page 7
Step 5 Ø * 7 10 Hex Key FOOTBOARD Secure part to parts with screw (E) using Hex Key (J). Step 6 Ø * 7 10 Hex Key FOOTBOARD Secure part to parts with screw (E) using Hex Key (J).
Page 8
Step 7 Ø3,5*16mm CORNER I I I I HEADBOARD Step 8 Ø3,5*16mm CORNER I I I I FOOTBOARD...
Page 9
Step 9 Ø 1/4 10 1/4mm Hex Key In this step, please do not In this step, please do not In this step, please do not In this step, please do not tighten the screw all the way. tighten the screw all the way. tighten the screw all the way.
Page 10
Step 10 Ø 1/4 10 1/4mm Hex Key In this step, please do not In this step, please do not In this step, please do not In this step, please do not tighten the screw all the way. tighten the screw all the way. tighten the screw all the way.
Page 11
Ø * 7 10 Finish tightening the screws from steps 9 and 10. Hex Key Secure part with screw (E) using Hex Key (J). Step 12 In this step please tighten all screws completely. Ø * 0mm Secure part to parts 10 with screw using Hex Key (J).
Page 12
Step 13 Ø3/16*1.1/2 3/16 3/16 part 27 to support (K) and washer using slotted head screwdriver. Step 14 Ø10*30mm Insert wooden dowel (D) as shown in the diagram. P.12...
Page 13
Step 15 In this step, distribute sets of slats 28 using the applied dowels as guides. Insert the set of slats as shown in the diagram. P.13...