Page 1
Item #: ISLB8B Assembly Instructions Please visit our website for the most current instructions, assembly tips, to report damage or request parts.www.walkeredison.com Revised 06/2023 - V1 Copyright 2018, by Walker Edison Furniture Co., LLC, All rights reserved.
Parts List Part# Description Part# Description Headboard Left Post Central Foot Headboard Right Post Central Support Footboard Left Post Union Support Footboard Right Post Set Slat Left side rail Upper Short Slat Right Side Rail Upper Long Slat Upper Rail / Lower Slat (HEADBOARD) Middle Slat (HEADBOARD)
Page 5
Step 1 Ø10*40mm Insert wood dowel (C) into parts (5,6,7,8,9,14 and (15). Step 2 Ø7*100mm Hex Key HEADBOARD Secure part 1 to parts 7, 9 and 14 with screw (E) using Hex Key (J). Align dowels in part 8 to holes in part 1.
Page 6
Step 3 Ø7*100mm Hex Key Secure part 2 to parts 7,9 and 14 with screw (E) using Hex Key (J). Align dowels in part 8 to holes in part 2. Step 4 Ø4* Pre Drilled Holes HEADBOARD...
Page 7
Step 5 Ø7*100mm Hex Key FOOTBOARD Secure part 4 to parts 9 and 14 with screw (E) using Hex Key (J). Step 6 Ø7*100mm Hex Key FOOTBOARD Secure part 3 to parts 9 and 14 with screw (E) using Hex Key (J).
Page 8
Step 7 Ø3,5*16mm Corner I I I I HEADBOARD Step 8 Ø3,5*16mm Corner I I I I FOOTBOARD...
Page 9
Step 9 In this step, please do not In this step, please do not In this step, please do not In this step, please do not tighten the screw all the way. tighten the screw all the way. tighten the screw all the way. tighten the screw all the way.
Page 10
Step 10 In this step, please do not tighten the screw all the way. Ø1/4*100mm FOOTBOARD 1/4mm Hex Key Secure part 5 and 6 to Footboard Post (3) and (4) and Barrel nut (B) using hex key. P.10...
Page 11
Ø7*100mm Finish tightening the screws from steps 9 and 10. Hex Key Secure part 15 with screw (E) using Hex Key (J). Step 12 In this step please tighten all screws to the end. Hex Key Secure part 11 to parts 10 with screw using Hex Key (J).
Page 12
Step 13 3/16 Ø3/16*1 1/2 3/16 Secure part 11 to support (K) with screw (L) and washer (N) and using slotted head screwdriver. Step 14 Ø10* 0mm Insert wooden dowel (D) as shown in the diagram. P.12...
Page 13
Step 15 In this step, distribute sets of slats using the applied dowels as guides. Insert the set of slats 13 as shown in the diagram. P.13...