Safety Instructions; Battery Care - Scanprobe X40 User Manual

Safety Instructions

This chapter illustrates the safety requirements that should always be adhered to when
operating or maintaining any product purchased from Scanprobe Techniques Limited or one
of their authorised agents. Please take the time to read and understand all the instructions
within this document.
Warning: Risk of injury due to electric shock:
When using electrical equipment, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, and personal injury.
Warning: Risk of damage to eyes and eyesight:
The X40 System features bright LED illumination on the camera head which may
cause damage to the eyes or to eyesight when fully illuminated. Do not look
directly at them or point them at other people's eyes when illuminated.
Safety Instruction for the X40 System:
Charging: Only use the power supply and charging cables supplied with the

equipment orthose that have been supplied by Scanprobe Techniques Limited (or
their approved suppliers).
Cables: Repair or replace all damaged cables immediately.

Lifting: Observe safe lifting procedures when lifting or moving any components

of this system.
Mains operation: The mains power adaptor supplied with the unit is not

intended for use in outdoor environments. Do not attempt to charge or operate
the unit from the mains supply outdoors.
Health and safety: Foul sewer systems and other watercourses can be a source

of biological hazards. Always use the appropriate PPE and take suitable
precautions to prevent infection when using the X40 System.
Checks: Before using the equipment, carefully check all parts to ensure there is

no damage.
Maintenance: The operator must ensure that all connectors and other interfaces

are kept free from dust and dirt.

Battery Care

The battery is protected within the X40 System case and is not exposed to the user in normal
operations. If the case is damaged and the battery pack is exposed:
Call Scanprobe Techniques Limited, or an approved service centre, to arrange for

the X40 System to be repaired. Do not use or charge an X40 System with an
exposed battery pack.
Do not send damaged batteries or cells through the mail service or by courier.

Do not tamper with an exposed battery pack.

Do not short-circuit a cell or the battery, or store a cell or the battery pack where

it may be short-circuited by other metal objects.
X40 User Manual
5
Version 1.0
29 June 2022