Table of Contents
Advertisement
4. Finish securing chute control assembly to chute
support bracket with wing nut and hex screw removed
earlier. See Figure 3-4.
5. Check that all cables are properly routed through the
cable guide on top of the engine. See Figure 3-5.
The extension cord is fastened with a cable tie to the rear
of the auger housing for shipping purposes. Cut the cable
tie and remove it before operating the snow thrower.
CAUTION: Prior to operating your
snow thrower, refer to Auger Control
Test on page 13. Read and follow all
instructions carefully, and perform all
adjustments to verify your snow thrower
is operating safely and properly.
Shear Pin Storage (optional)
An area for convenient shear pin storage is located under
the plastic dash panel. See Figure 3-6.
Figure 3-4
Figure 3-
Figure 3-6
3
Setting Up
Your Snow
Thrower
CAUTION
Prior to operating
your snow thrower,
refer to Auger Control
Test on page 13.
Read and follow all
instructions care-
fully and perform all
adjustments to verify
your unit is operating
safely and properly.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Two Stage Snow Thrower and is the answer not in the manual?
Questions and answers
WHERE IS THE GEAR SHAFT ON MY STAGE 2 CLUB CADET MODEL 31BM5 CVR596
WHERE IS THE GEAR SHAFT ON A STAGE 2 CLUB CADET?
The gear (hex) shaft on a Cub Cadet Two Stage Snow Thrower is located beneath the lower frame cover. To access it, carefully pivot the snow thrower up and forward so that it rests on the auger housing, then remove the lower frame cover by taking out the two securing screws.
This answer is automatically generated