34
Check transmission oil level
In order to check the transmission oil level the control screw
removed. Oil should just barely escape from the inspection opening when the
motorcycle is in an upright position. If necessary, remove the plug
up with oil (see technical data- engine).
T
RANSMISSION AND CLUTCH WILL BE SUBJECTED TO EXCESSIVE WEAR AND TEAR IF YOU USE
TOO LITTLE OR LOW GRADE OIL
1
Changing the transmission oil *
To change the transmission oil run the engine warm and set up the motorcy-
cle on a horizontal surface. Remove the oil drain screw
into a container. Clean the magnet of the oil drain screw and reinstall oil drain
screw with seal. Pour in 0.7 litres engine oil (see technical data engine), repla-
2
ce plug
T
RANSMISSION AND CLUTCH WILL BE SUBJECT TO EXCESSIVE WEAR AND TEAR
LITTLE OR LOW GRADE OIL
2
3
!
CAUTION
. U
SE ONLY HIGH
and check engine for leaks.
CAUTION
!
. U
-
SE ONLY HIGH
GRADE OIL
1
is to be
2
and top
!
-
.
GRADE OIL
3
and drain used oil
!
,
IF YOU USE TOO
.