Dealer Checklists - Woods SB54.30 Operator's Manual

DEALER PRE-DELIVERY CHECKLIST
(DEALER'S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to
ensure it is set up properly before delivering it to the
customer.
The following check lists are a reminder of points to in-
spect. Check off each item as it is found satisfactory or
after proper adjustment is made.
Check that all safety decals are installed and in
good condition. Replace if damaged.
Check that shields and guards are proper-
ly installed and in good condition. Replace if
damaged.
Check all bolts to be sure they are tight.
Check that all cotter pins and safety pins are
properly installed. Replace if damaged.
Check and grease all lubrication points as identi-
fied in "Service, lubrication information".
Check the level of gearbox fluids before delivery.
Service, if required, as specified in the "Service,
lubrication information."
MAN1367
( 10/16/2023 )
MAN1367_2023-10.indd 33 MAN1367_2023-10.indd 33

DEALER CHECKLISTS

DELIVERY CHECKLIST
(DEALER'S RESPONSIBILITY)
Show customer how to make adjustments and
select proper PTO speed.
Instruct customer how to lubricate and explain
importance of lubrication.
Point out the safety decals. Explain their mean-
ing and the need to keep them in place and in
good condition. Emphasize the increased safety
hazards when instructions are not followed.
Present Operator's Manual and request that cus-
tomer and all operators read it before operating
equipment. Point out the manual safety rules,
explain their meanings and emphasize the in-
creased safety hazards that exist when safety
rules are not followed.
Show customer how to make sure driveline is
properly installed and that spring-activated lock-
ing pin or collar slides freely and is seated in
groove on tractor PTO shaft.
Explain to customer the potential crushing haz-
ards of going underneath raised equipment.
Instruct customer that service work does not re-
quire going underneath unit and never to do so.
Point out the correct mounting and routing of
hydraulic hoses. Explain that during operation,
mounting, dismounting and storage, care must
be taken to prevent hose damage from pulling,
twisting and kinking.
Show customer the safe, proper procedures to
be used when mounting, dismounting, and stor-
ing equipment.
For mounted units, add wheel weights, ballast in
front tires, and/or front tractor weight to enhance
front end stability. A minimum 20% of tractor and
equipment gross weight must be on front trac-
tor wheels. When adding weight to attain 20%
of tractor and equipment weight on front tractor
wheels, you must not exceed the ROPS weight
certification. Weigh the tractor and equipment.
Do not estimate!
Make customer aware of optional equipment
available so that customer can make proper
choices as required.
Point out all guards and shields. Explain their im-
portance and the safety hazards that exist when
not kept in place and in good condition.
Dealer Checklist 33
10/18/23 10:16 AM 10/18/23 10:16 AM