Table of Contents
Advertisement
Figure 8. Shear Bolts
WARNING
■ Never direct discharge toward people, animals,
or property. Rocks, snow, ice and other materials
can be thrown up to 300 feet during operation.
■ Know where you are operating. Remove all un-
wanted trash and debris before starting. It can
wrap around auger or be thrown out of machine
during operation.
■ Keep auger and fan in good condition. Do not
operate with a damaged fan or auger.
■ Do not allow the auger to hit and scalp ground
during operation. Hitting ground will pick up soil
or rocks that can be thrown out of machine.
Adjusting Discharge Direction
To change direction of snow discharge, turn the manual
rotation handle clockwise to turn the chute to the right.
If this snow blower is equipped with the optional hy-
draulic chute rotation, activate the appropriate tractor
controls to rotate the chute. Reverse hoses if the rota-
tion is not in the desired direction.
NOTE: For hydraulic rotator option, if chute turns too
quickly, adjust flow control on tractor hydraulics.
NOTE: Operating hydraulic deflector cylinder re-
quires low tractor flow rates. When initially operating
cylinder reduce tractor hydraulic flow rate toprevent
deflector damage and improve resolution of deflector
adjustment.
16 Operation
MAN1367_2023-10.indd 16
MAN1367_2023-10.indd 16
Adjusting Discharge Chute
Deflector Position
The height of snow discharge is controlled by position
of chute deflector on discharge chute.
To adjust the deflector angle, unscrew the plastic
handle and select a notch at the desired angle. It is
recommended to use the notches, but it is possible
to adjust the angle between two notches. Tighten the
plastic handle.
If this snow blower is equipped with a hydraulic deflec-
tor, activate the tractor controls to move the deflector.
Reverse hoses if movement of the deflector is not in
the desired direction.
If this snow blower is equipped with an electric deflec-
tor, operate the switch to move the deflector.
NOTE: If possible, blow snow with the wind. Beware of
people or buildings in the area.
Figure 9. Discharge Chute Position
WARNING
■ Keep bystanders away from equipment.
■ Wear appropriate hearing protection.
10. Depth of cut can be controlled with the skid shoes.
11. Adjust the snow blower so that the skid shoes run
level and according to the surface conditions so that
stones are not thrown with the snow. Make sure the
skid shoes are at the same height to keep cutting
edge leveled. To adjust, remove the bolts (item 2)
and reinsert them in the appropriate hole according
to the following:
•
On level paved surfaces - Use the lower holes.
•
On uneven surfaces or gravel - Use the middle
or upper holes.
MAN1367
( 10/16/2023 )
10/18/23 10:15 AM
10/18/23 10:15 AM
Advertisement
Table of Contents
