Table of Contents
Advertisement
Figure 19. Rotator Support Assembly
Figure 20. Handle Support Assembly
6. Figure 21 – Install plastic handle (5) over rotation
handle (6).
7. Insert rotation tube (1) inside the rotation worm
assembly (2). Align holes and insert a 10-24 x 1"
socket head capscrew (3) and secure with nylon in-
sert locknut (4).
26 Assembly
MAN1367_2023-10.indd 26
MAN1367_2023-10.indd 26
8. Insert the rotation handle (6) through the grommet in
upper handle support (7) and into the rotation tube
(1). Select desired length, align nearest holes and
secure with a 4mm x 80mm hairpin (8). The length
will be adjusted later for a convenient position on
your tractor.
9. Adjust the rotator worm assembly (2) so it fits snugly
against the teeth on the chute, but still turns freely.
Tighten the 1/4" NC x 1" bolts and nuts slightly.
10. Rotate the chute completely to the right then to the
left using the rotation handle.
•
If the chute is too hard to turn it's because the
rotation worm is engaged too deep between the
gear teeth, move the worm slightly away from
the gear teeth and try again.
•
If the chute rotates with difficulty because the
teeth do not engage or engage incorrectly, ad-
just the rotation handle support toward the chute
and redo the steps.
•
If the handle hairpin interferes with the chute ad-
justment arm, reverse the direction of the handle
support bracket (5) for more clearance.
11. When the chute rotates easily and completely, tight-
en the 1/4" NC bolts and nuts to the specification
in the Bolt Torque Chart and lubricate the rotation
worm.
12. After the snow blower has been attached to the trac-
tor, adjust the rotation handle height and length to a
comfortable position that does not contact any part
of the tractor as the three-point hitch is raised.
Figure 21. Rotator Handle Assembly
MAN1367
( 10/16/2023 )
10/18/23 10:16 AM
10/18/23 10:16 AM
Advertisement
Table of Contents
