Woods SB54.30 Operator's Manual page 23

Gearbox
Change oil in the gearbox after the first 30 hours, or 30
days of operation. After that, follow the lubrication
chart instructions to check monthly. It is best to change
the oil at the end of the season to remove moisture and
contaminants.
■ Before proceeding, read and follow all safety
rules.
To check oil level:
1. Remove the plug (1).
2. If the oil level is not up to the bottom of the hole, fill
with SAE 80W90 oil until it flows out the level plug
hole.
3. Reinstall the plug (1).
To change the oil:
1. Run the snow blower briefly to warm the oil and sus-
pend the contaminants.
2. Remove the plug (1).
3. Remove the oil through the level plug hole using a
suction pump.
4. Refill with SAE 80W90 oil until it flows out the level
plug hole.
5. Reinstall the plug (1).
Figure 15. Gearbox Oil
Skid Shoe Adjustment
The machine is equipped with skid shoes on bottom
side of each side plate to prevent wearing frame and to
provide depth control. They should be checked occa-
sionally for wear and replaced if required.
■ Before proceeding, read and follow all safety
rules.
1. Place a 4" x 4" block under each end of snow blower
frame.
MAN1367
( 10/16/2023 )
MAN1367_2023-10.indd 23 MAN1367_2023-10.indd 23
WARNING
WARNING
NOTE: Block only high enough for the skid shoes
to clear ground.
2. Lower snow blower to sit securely on blocks.
3. Properly secure tractor and release all hydraulic
pressure.
4. Loosen and remove skid shoe mounting bolts and
nuts (2).
5. Remove skid show and inspect for wear or other
damage - Replace as needed.
6. Reassemble skid shoe and adjust for the desired
height.
7. Tighten mounting bolts and nuts (2) per specifica-
tions in the Bolt Torque Chart.
Figure 16. Skid Shoe Adjustment
PTO Driveline Guard
The shield must turn freely on PTO shaft. Daily lubrica-
tion of both shield bearings and periodic cleaning will
ensure safe operation of the shield.
If shield is damaged or worn, replace components with
genuine Woods service parts.
Comer Driveline
1. Rotate three rectangular plastic pins with a screw
driver 90°.
2. Lift pins out with screw driver.
3. Remove bell housing and shaft.
4. Replace components as needed. Follow steps 1
through 3 in reverse.
DP6
Figure 17. Comer Driveline
Owner Service 23
10/18/23 10:16 AM 10/18/23 10:16 AM