Woods SB54.30 Operator's Manual page 31

2. Figure 38: Attach the electric actuator rod (1a) to the
base of the chute (item 2) with a 3/8" x 1-1/2" hex
bolt and nylon insert locknut (3, 4). Attach the base
side of the electric cylinder (1b) to the deflector (5)
with a 3/8" x 1-1/2" hex bolt and nylon insert locknut
(3, 4). Do not over tighten the bolts to allow free
movement of the electric cylinder.
NOTE : Be sure to attach the actuator as shown in
the figure to avoid damaging the electric cylinder.
Figure 38. Attach Electric Actuator
3. Figure 39: Attach the hose support (1) to the right
bracket (2) of the upper three-point hitch using two
3/8"NC x 1-1/2" hex bolts and nylon insert locknuts
(3, 4).
Figure 39. Attach Hose Support
4. Figure 40: Run the actuator electric harness (1) over
the snow blower without interfering with the sharp
edges, or maintenance of the snow blower. Secure
it on the hose support (2) with a nylon tie (3), leaving
a gap on the harness length. Rotate the chute to
maximum right and left, check if the harness is long
enough and does not interfere with any snow blower
component.
NOTE : This is a suggested routing of the electric
harness of the actuator. In this way, there is less
risk of the harness being caught in the rotation sys-
tem of the chute. However, other configurations are
also possible. In any case, make sure that there is
enough harness length so that the chute can rotate
to the maximum right and left without forcing on the
harness.
MAN1367
( 10/16/2023 )
MAN1367_2023-10.indd 31 MAN1367_2023-10.indd 31
5. Install the snow blower on the tractor by following
the instructions of the Operation Section.
Figure 40. Secure Wiring Harness
6. Figure 41: Attach the switchbox (1) to the rod of the
valve lever (2) with a switchbox clamp (3), two 1/4"
x 1" hex bolts and lockwashers (4, 5) Do not tighten
to allow position adjustment the later.
NOTE : If your tractor is not equipped with a valve
lever, it is possible to position the switch in another
place so that it is easily accessible but it must not
interfere with the controls already present on the
tractor.
Figure 41. Attach Switch Box
7. Figure 42: Connect the 2-connector terminal of the
187" electric harness (blue and black) to the 2-con-
nector terminal of the actuator.
8. Run the 187" electric harness (blue and black) in
the tractor to the switchbox. Raise and lower the
snow blower to maximum positions to check if the
harness is long enough and does not interfere with
any component.
Figure 42. Connect Wiring Harness
Assembly 31
10/18/23 10:16 AM 10/18/23 10:16 AM