Woods SB54.30 Operator's Manual page 32

9. Figure 43: Connect the flat terminal of the 72" red
wire to terminal A of the switch. Then connect the
flat terminal of the white wire to terminal B of the
switch.
10. Simulate the position of the switch in the switchbox
and cut off the excess of the blue wire. Strip the
end of the wire 1/4", insert a shrink tubing and crimp
a 1/4" female flat terminal. Then reassemble the
shrink tubing on the terminal and heat with a hot air
gun. Connect this wire to terminal C of the switch.
11. Cut off the excess of the black wire. Strip the end of
the wire 1/4", insert a shrink tubing and crimp a 1/4"
female flat terminal. Then reassemble the shrink
tubing on the terminal and heat with a hot air gun.
Connect this wire to terminal D of the switch.
12. 1Attach the switch (1) to the switchbox (2) with its
nut and knurled nut and install the switch cap (3).
Paste the decal (4) on the switchbox (2).
13. Position the switchbox (2) in a comfortable operat-
ing position and tighten the two 1/4" x 1" hex bolts
to secure the switchbox to the valve lever. Secure
the wires to the switchbox and the valve lever with
a nylon tie wrap using the notches provided on the
switchbox.
14. Locate a wire on the tractor that is an accessory
power source, that is, that has current only when the
ignition is switched on.
32 Assembly
MAN1367_2023-10.indd 32 MAN1367_2023-10.indd 32
Figure 43. Electrical Diagram
15. Secure the tap connector to the selected power
source and bring the red wire to the tap connector,
cutting off the excess if necessary. Secure in place
by lowering the metal blade of the connector.
16. Find a bolt on the tractor that can be used as a
ground connection. Bring the white wire to this loca-
tion and securely fasten to the chosen bolt.
17. Install the protective loom on both wires (blue and
black) from the snow blower to the switchbox and
cut off the excess. Install the protective loom on
the two power wires (red and white) and cut off the
excess. Apply electrical tape to hold enclosures
closed. Fasten everything in place on the tractor
with nylon tie wraps.
18. Make sure to lower and rise the snow blower and
rotate the chute into all positions to see if the elec-
tric harness is long enough and do not interfere with
any component.
NOTE: If the functions are opposite to the direction
of the switch, only reverse the blue wire and the
black wire.
■ For continued protection against risk of fire,
replace ONLY with a fuse of the same type and
having the same electrical rating.
CAUTION
MAN1367
( 10/16/2023 )
10/18/23 10:16 AM 10/18/23 10:16 AM