Installation Instructions
Original Instructions
ASEM 6300 On-Machine Monitors and On-Machine Panel PCs
Catalog Numbers 6300MA, 6300PA
Topic
ATTENTION: Read this document and the documents listed in the
equipment before you install, configure, operate, or maintain this product. Users are required to familiarize themselves with installation and wiring
instructions in addition to requirements of all applicable codes, laws, and standards.
Activities including installation, adjustments, putting into service, use, assembly, disassembly, safety, and maintenance are required to be carried out
by suitably trained personnel in accordance with applicable code of practice. If this equipment is used in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired.
Summary of Changes
This publication contains the following new or updated information. This list includes substantive updates only and is not intended to reflect all changes.
Topic
Added information about adapter plates in Mounting Requirements section
Updated location of I/O ports in Location of I/O Ports table
Compliance
ATTENTION: If a SIL-3 E-stop button is used, familiarize yourself with the Safety section in the ASEM On-Machine User Manual, publication 6300-UM002.
UL/cUL Mark Compliance
Equipment with the UL/cUL mark complies with the requirements of UL 61010-1, UL 61010-2-201, CSA C22.2 No. 61010-1, and CSA C22.2 No. 61010-2-201.
A copy of the certificate of compliance is available at rok.auto/certifications.
European Union Directive Compliance
This equipment meets the European Union Directive requirements when installed within the European Union or EEA regions and have the CE marking.
A copy of the declaration of the conformity is available at rok.auto/certifications.
ATTENTION: This equipment is intended to operate in an industrial or control room environment, which uses some form of power isolation from the
public low-voltage mains. Some computer configurations cannot comply with the EN 61000-3-2 Harmonic Emissions standard as specified by the EMC
Directive of the European Union.
All I/O cables must be used only indoors.
IMPORTANT
To comply with EN 61326-1, be sure that the selected cables comply with the attribute listed in
All I/O cables must be used only indoors, and USB cables must be less than 3 m (9.84 ft) in length.
Page
1
2
2
3
4
5
5
6
7
7
8
Additional Resources
section about installation, configuration, and operation of this
Page
3
6
Table 5 on page
6.