en Troubleshooting
Fault
"E:30 / -10" and/or
lights up.
flashes.
"Hot" and the drum ro-
tates.
"H:95" lights up altern-
ately with End.
46
Cause and troubleshooting
If the error message is displayed again, call cus-
4.
tomer service.
→ "Customer Service", Page 57
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
▶
out.
The pump unit is not inserted.
Insert the pump unit into the detergent drawer.
1.
→ "Cleaning the detergent drawer", Page 39
Push in the detergent drawer until the symbol goes
2.
out.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the washing programme", Page 33
▶
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 26
Door is not closed.
Close the door.
▶
Laundry is caught in the door.
Remove any trapped laundry.
▶
Cooling process active.
Not a fault.
1.
Do not change the programme during the cooling
2.
process.
Note: The cooling process takes up to 10 minutes.
You can continue to operate the appliance.
Drum cleaning is required.
→ "Cleaning the drum", Page 38
▶
The water pressure is low.
See
▶
→ "E:30 / -10 and/or
", Page 46