Table of Contents
Advertisement
System settings
MIDI overall settings
(COMMON)
1.
Hold down [SHIFT] and press the [3] button to access the
COMMON setting screen.
2.
Make settings as described in steps 2-4 of "System
settings.
э Overall settings (SYSTEM) (p. 52)
MIDI Channel
This is the channel on which MIDI data will be transmitted
and received via MIDI IN/OUT.
Turn this "OFF" if you do not want to switch patches using
MIDI messages, or if you do not want knob movements to be
transmitted via MIDI.
« Values >
1-16, OFF
MIDI CHANNNEL
Unit ID number (Device ID)
This sets the device ID number for system exclusive
messages, allowing different units of the same model to be
distinguished. System exclusive messages will be received
only if the device ID within the message matches the device
ID number specified on the receiving MIDI device.
This setting makes it possible to simultaneously and
independently send system exclusive messages to multiple
EF-303 units.
« Values »
DEVICE ID
32
* The device ID for a bulk dump (a type of system exclusive
message) is transmitted with the setting you make here.
Soft Thru
This allows messages received at MIDI IN to be
retransmitted (THRU'ed) without change from MIDI OUT.
When this function is turned "ON," MIDI messages received
at the MIDI IN connector will be retransmitted without
change from the MIDI OUT connector. (Le., the MIDI OUT
connector can be used as a MIDI THRU connector.)
« Values >
ON, OFF
OFF
SOFT THRU
Local Switch
This specifies whether messages from the controller section
(e.g., sliders and knobs) will be transmitted to the internal
effect. If this setting is "OFF," messages from the controllers
will not be transmitted to the internal effect.
« Values >
ON, OFF
LOCAL SWITCH
ON
MIDI transmit/receive
settings (TX/RX)
1.
Hold down [SHIFT] and press the [4] button to access the
TX/RX setting display.
2. Make settings as described in steps 2-4 of "System
settings".
э Overall settings (SYSTEM) (р. 52)
Program change reception
(RX.Program Change)
Specify whether the EF-303 will receive program change
messages. If this is "OFF," program changes will not be
received.
« Values >
ON, OFF
»
F
RX.PROGRAM
CHANGE
OFF
Advertisement
Table of Contents
