Table of Contents
Advertisement
Slider control change / note
number setting
This sets the MIDI messages (control change or note) sent
from the step modulator.
« Values »
CC02-CC05, CC07-CC31, CC64-CC95, NOTE
[STEP
MODULATOR]
CC No/NOTE
Slider destination setting
This sets the destination to which MIDI messages from the
step modulator will be sent.
« Values >
INT: Messages from the knobs will be sent only to the
internal effect.
EXT: Messages from the knobs will be sent only from MIDI
OUT.
BOTH: Messages from the knobs will be sent both to the
internal effect and from MIDI OUT.
[STEP
í
MODULATOR) BS
BOTH
EXT
INT
54
Synchronization settings
(SYNC)
1.
Hold down [SHIFT] and press the [MANUAL] button to
access the SYNC setting display.
2.
Use steps 2-4 of "System settings" to make settings.
= Overall settings (SYSTEM) (p. 52)
Synchronization (Sync Mode)
This setting specifies how the step modulator will operate,
and how MIDI Clock will be transmitted or received.
« Values »
SYNC MODE
INT
SLAVE
REMOTE
INT: BPM will be controlled by the internal tempo clock.
Even if MIDI Clock messages are received from an external
device, they will be ignored.
SLAVE: The BPM will synchronize to the MIDI Clock from
an external device. The step modulator will not play when
you press the [START/STOP] button.
REMOTE: Basic operation is the same as for "INT."
However, Start/Stop messages from an external MIDI device
can be used to start/stop the step modulator.
Synchronization message
transmission (Sync Ош) setting
Specify whether synchronization-related MIDI messages will
be transmitted.
« Values »
ON, OFF
ERE). ШЕП ЕМА
SYNC OUT
ON
OFF
Advertisement
Table of Contents
