HP CX 6300 Installation And Getting Started Manual page 34

2. Check the LEDs on the switch to make sure the switch is on and operating.
When the switch is powered on, it performs its diagnostic self-test and initialization. This boot
process, depending on switch model and configuration, takes approximately 1-2 minutes to
complete.
Disconnect power from the switch
Disconnect the power cord from all of the switch power supplies and from the power sources.
Mount the switch
After the switch passes self-test, it is ready to be mounted in a stable location. Supported mounting options for the
HPE Aruba Networking 6300M switches include:
Two-post rack mount
n
Tabletop or desktop
n
Four-post rack mount (Requires the optional J9583A HPE X410 Universal Rack Mounting Kit.)
n
Do not mount the switch on a wall, under a table, or under another horizontal surface.
Mounting a switch on a tabletop or desktop
Before you begin:
Locate the four self-adhesive pads included in the switch accessory kit.
n
Select a secure horizontal surface where the network cables and switch power cord will not create a tripping
n
hazard.
To mount the switch to a tabletop or desktop:
1. Attach the four self-adhesive pads to the bottom corners of the switch.
Installing the switch | 34