Setting The Speaker Impedance - Yamaha RX-V2700 Owner's Manual

Setting the speaker impedance

CAUTION
If you are to use 6 ohm speakers, set "SPEAKER
IMP." to "6ΩMIN" as follows BEFORE using this
unit. 4 ohm speakers can be also used as the
front speakers.
AUDIO TONE REC OUT/
SELECT CONTROL ZONE2 A/B/C/D/E PRESET/TUNING
INPUT
STRAIGHT
MAIN ZONE
EFFECT
YPAO SILENT CINEMA
ON/OFF
PROGRAM OPTIMIZER
MIC PHONES
ON
OFF
MASTER
2,5 3 2,4
1
Make sure this unit is turned off.
See page 34 for details about turning on or off this
unit.
2
Press and hold STRAIGHT on the front panel
and then press MASTER ON/OFF inward to
the ON position to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
While holding
down
STRAIGHT
EFFECT
3
Rotate the PROGRAM selector on the front
panel to select "SPEAKER IMP.".
The following display appears in the front panel
display.
PROGRAM
SPEAKER
(U.S.A. model)
PURE DIRECT
VOLUME
PRESET/ MEMORY TUNING
TUNING FM/AM MAN'L/AUTO FM MODE ENHANCER NIGHT
EDIT
ZONE ON/OFF ZONE CONTROLS
MULTI ZONE
ZONE 2 ZONE 3
S VIDEO VIDEO L AUDIO R OPTICAL
VIDEO AUX USB
MASTER
IMP.
8 M I N
4
Press STRAIGHT on the front panel
repeatedly to select "6ΩMIN".
The following display appears in the front panel
display.
STRAIGHT
SPEAKER
5
Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to save
the new setting and turn off this unit.
MASTER
Note
The setting you made is reflected next time you turn on this
unit.
CONNECTIONS
EFFECT
IMP.
6 M I N
33
En