Setting Remote Control Codes - Yamaha RX-SL80 Owner's Manual

Setting remote control codes

Once you set the appropriate remote control codes, you
can use this remote to control your other components.
Note that some buttons may not correctly operate the
selected component. Use the input selector buttons to
select the component you want to operate. The remote
control automatically switches to the appropriate control
mode for that component.
Default codes
The following table shows the default component
(Library: component category) and the remote control
code for each area.
Input area Manufacturer
TV (DTV/CBL)
VCR
DVD (DVD/CD)
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try to set another YAMAHA remote control code.
Setting a code
1
Hold down CODE SET while doing steps 2
and 3.
CODE SET
2
Press an input selector button to select the
source component you want to set up.
DVD/CD
DTV/CBL
Code
YAMAHA 299
YAMAHA 399
YAMAHA 699
VCR VIDEO 1
TUNER VIDEO 2
3
Press the numeric buttons to enter the three-
digit remote control code for the component
to be used, then release CODE SET.
STEREO HALL
1 2
MUSIC ENTERTAIN
5 6
STANDARD NIGHT
9 0
Refer to "LIST OF REMOTE CONTROL CODES" at the
end of this manual.
y
To reset an input area's remote control code to the factory default,
input the default code (see "Default codes" above) in step 3.
Notes
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you wait for more than 10 seconds during step 3, the setup
process is canceled. If this happens, start over from step 2.
• Replace the batteries frequently. The settings may be lost after
two minutes without power supply.
• If the remote control code is successfully set, "Code Set OK"
appears in the front panel display of this unit. If the setting is
not successful, "Code Set NG" appears.
REMOTE CONTROL FEATURES
JAZZ ROCK
3 4
TV THTR MOVIE
7 8
EXTD SUR. STRAIGHT
+10 ENT
EFFECT
45