Setting Remote Control Codes - Yamaha RX-V461 Owner's Manual

Remote control features

Setting remote control codes

You can control other components by setting the
appropriate remote control codes. For a complete list of
available remote control codes, refer to "List of remote
control codes" at the end of this manual.
Remote control code default settings
Input Component
source category
CD CD
MD/CD-R CD-R
DVD DVD
DTV/CBL –
TUNER TUNER
V-AUX –
USB USB
DVR DVR
–
Note
You may not be able to operate your Yamaha component even if a
Yamaha remote control code is preset as listed above. In this case,
try setting another Yamaha remote control code.
62
En
Default
Manufacturer
code
YAMAHA 5013
YAMAHA 5001
YAMAHA 2000
– –
YAMAHA 5007
– –
YAMAHA 5012
YAMAHA 2011
– –
1
While pressing and holding one of the input
selector buttons (C) on the remote control to
select the input area you want to set up,
press AV POWER for more than 3 seconds.
CD MD/CD-R TUNER
DVD DTV/CBL DVR
V-AUX USB
While holding down
2
Press the numeric buttons (0 to 9) ( X ) to
enter the four-digit remote control code for
the component to be used.
Notes
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you do not press any buttons within 30 seconds in step 2, the
setup process is canceled. If this happens, repeat the setup
procedure.
POWER
AV
Press for 3 seconds