Table of Contents
Advertisement
_ |
If the automatic black balance adjustment function
If the automatic white balance adjustment function
does not work normally:
does not work normally:
The following indications will appear on the viewfinder
screen.
TRY AGAIN
:LENS CLOSE?
Cause: The lens iris did not close automatically during
black balance adjustment.
Check: ¢ The lens function
e The lens connection
CB SW
MISS TOUCH?
Cause: The BARS/WB selector is set to BARS during
the black balance adjustment.
Check: The BARS/WB selector. Is it set to AUTO?
Try to make the black balance adjustment again after
eliminating the problems described above.
The following indications will appear on the viewfinder
screen.
TRY AGAIN
:C. TEMP.LOW
se :C.TEMP.HI
CHG.FILTER
CHG.FILTER
Cause: An inappropriate color temperature conversion
filter was used.
Check: The filter type
Cause: ¢ A white object was not used to make the
adjustment.
¢ The adjustment was made with a very bright
object inside the minimum white area
required for white balance adjustment.
Check: The white pattern or object, and refer to Step 3
of the "White Balance and Black Balance
Adjustments".
:LOW LIGHT
Cause: The light is insufficient.
Check: ¢ The lighting. If necessary, increase it.
¢ The video output level. If necessary, raise it
using the GAIN selector.
Try to make the white balance adjustment again after
eliminating the problems described above..
TALIAATIUH
EL
1. GENERAL
DESCRIPTI
Memorized white balance and black balance values
In the DXC-325/325P, a built-in memory stores the adjusted white
balance and black balance values. The memorized values will be
retained for about 12 hours after the power is turned off without
any further power supply to the camera or until the adjustments
are made once again. If the memorized values are erased,
"sMEMORY NG" will be displayed on the viewfinder screen next
time the camera power is turned on. If this happens, adjust the
white balance and biack balance.
DXC-325 (UC)
DXC-325P (EK)
To start recording immediately without white balance
adjustment
Set the BARS/WB selector to 3200 K to obtain the white balance
value preset at the factory.
Black setting
When the AUTO W/B BAL switch is set to BLK, the black level
drift (with respect to the reference black level) of each channel
(R, G, B) is automatically adjusted, together with the black
balance.
1-21
Advertisement
Table of Contents
