Enjoying Unprocessed Input Sources (Straight Decoding Mode); Enjoying Sound Field Programs Without Surround Speakers (Virtual Cinema Dsp); Enjoy Sound Field Programs With Headphones (Silent Cinema™); Using Cinema Dsp 3D Mode - Yamaha HTR-6260 Owner's Manual

Enjoy the sound field programs
Enjoying unprocessed input sources
(Straight decoding mode)
In straight decoding mode, sounds are reproduced without
sound field effect. 2-channel stereo sources are output
from only the front left and right speakers. Multi-channel
input sources are decoded straight into the appropriate
channels and multi-channel sounds are reproduced
without a sound field effect.
1
To enable straight decoding mode, press
MSTRAIGHT (or kSTRAIGHT).
"Straight" appears on the front panel display.
2
To cancel straight decoding mode, press
MSTRAIGHT (or kSTRAIGHT) again.
A sound field program name appears on the front
panel display, and sound is reproduced with that
sound field effect.
Enjoying sound field programs without
surround speakers (Virtual CINEMA
DSP)
Virtual CINEMA DSP allows you to enjoy DSP sound
field surround effects even without any surround speakers
by using virtual surround speakers. You can even enjoy
Virtual CINEMA DSP using a minimal two-speaker
system that does not include a center speaker.
When "Sur. L/R SP" in the setup menu is set to "None"
(see page 52), this unit operates in Virtual CINEMA DSP
mode.
Note
• Virtual CINEMA DSP is not available in the following conditions even if
you set "Sur. L/R SP" to "None" (see page 52).
– headphone plug is connected to the PHONES jack.
– 7ch Stereo of the field sound program is selected.
– Pure Direct mode or straight decoding mode is used.
28
En
Enjoy sound field programs with
headphones (SILENT CINEMA™)
SILENT CINEMA allows you to enjoy multi-channel
sources with your headphones. SILENT CINEMA mode
is automatically selected when you connect the headphone
plug to the PHONES jack.
Note
• SILENT CINEMA mode is not available in the following conditions.
– 2ch Stereo of the sound field program is selected.
– Pure Direct mode or straight decoding mode is selected.

Using CINEMA DSP 3D mode

CINEMA DSP 3D mode creates the intensive and
accurate stereoscopic sound field in the listening room.
To use this unit in CINEMA DSP 3D mode, presence
speakers are required. Connect the presence speakers to
the EXTRA SP jacks, perform the following settings and
select a CINEMA DSP related sound field program.
• Set the "Extra SP Assign" to "Presence" (see page 51).
• Enables the CINEMA DSP 3D in the setup menu (see
page 47).
• Disconnect the headphones from the PHONES jack.
When the sound field program runs in CINEMA DSP 3D
mode, the 3D indicator on the front panel lights up.