Installing the FIX-030 Table Mount
The FIX-030 table mount can be installed using a weighted or grommet base.
To install the FIX-030 table mount to the display, follow these steps:
1. Disconnect the AC power adaptor from the power source to turn off the
display.
2. Install the Pole to the Weighted Base or to the Grommet Base, and secure
with three M5 x 14 bolts using an Allen Key. For a Grommet Base, attach a
soft pad at the base.
NOTE: If an existing grommet hole comes with a plastic protector, remove
it to ensure to have a flat surface before installing the table mount.
3. To install the table mount to a hole in a desk, drill a 10 mm hole and secure
the mount with a Support Plate, M10 Washer, Spring Washer, and M10 Bolt
using a wrench.
4. Install the Monitor Arm to the pole. Fasten the bolt with an Allen Key.
Attach the Wire Clip to the pole.
19