TechniSat DIGICLOCK 1 Manual page 23

01 - beep, 02 - waking up with FM radio.
Then, please confirm the selection with the ALARM button.
>
6.2 Turning off alarm
> The alarm will be automatically activated after configuring the alarm settings.
The readiness of the alarm is indicated by the lit ALM LED.
> To deactivate the alarm function, please press and hold the ALARM button
until the ALM LED goes out. The alarm will not be activated.
6.3 Snooze function
> To activate the snooze function during the alarm, please press the SNOOZE/
DIMMER button. The alarm will be silenced for 10 minutes. After 10 minutes,
the alarm will be triggered again.
> To turn off the alarm, press any button (except SNOOZE/DIMMER). The alarm
will be turned off and will re-activate after 24 hours.
If the user doesn't turn off the alarm, it can sound for 10 minutes for the beep
option (01) and one hour for the FM radio option (02).
7 Brightness adjustment
> Press the SNOOZE/DIMMER button to adjust the 6 levels of display brightness
8 Battery installation
> Turn the device to open the battery compartment at the back.
> Carefully remove the battery compartment cover. When inserting batteries
(2 x AAA, 1.5V), please pay attention to the correct polarity.
> Carefully close the battery compartment cover, ensuring that the cover's
locking clips fit into the housing.
PL
EN
FR
NL
23